Instructions for use a timber mill, power, see rotation is correct. 2, when installed for knives, cutter blade protruding plane 2-4mm, then tighten the bolts. If found threaded bolt pressure wear should be replaced immediately to prevent the loss of slip nut cutter. 3, the degree of change in China retractable knife grinder timber must be the same length stretch knife. 4, by adjusting the length of the knife, when the particles reach the ideal timber mill branches, change Luo different aperture sieve. 5. Do entrainment stone, wood inside the nail into the machine to prevent broke a knife and trim. 6, pay attention to check the hammer bolts found loose, tighten immediately, Hubei timber mill, hammer and bolt should be replaced when worn serious. Wood chippers feeding should be uniform, if found to have noises, bearing and body temperature is too high or outward spray timber mill feed and other phenomena, should immediately stop inspection, troubleshooting. Wood chippers are done before the start-up and shutdown circuit checks to avoid leakage from happening. The length of the timber must be moderate, not too long, and 30 cm below the optimum, not too thick. Discharge port and inlet at four weeks as some spacious, avoid some accidents. Chinese timber mill, lumber mill even the state, the sun machinery provided by the sun Machinery Manufacturing Co., Ltd., Zhengzhou. Zhengzhou sun Machinery Manufacturing Co. (www.zymufenji.com) strong, credible, in Zhengzhou machining industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead sun machinery and you hand into the brilliant, for a better future!